304 Clutch problem

[colliwobble]

I have just replaced the clutch plate 190mm, oil seals, Overhaul the Master and new Slave cylinder but I still have very little clearance to the extent that the gears hardly clear! The only component not replaced is the pressure plate because I just cannot find one! I vaguely remember when I served my time on them many years ago that we used to increase the length of the rod between slave and release bearing folk but I think that this would over extend the pressure plate fingers and lead to pressure plate failure!  Has anybody got a pressure plate Brevet Verto to suit or any better ideas!
Chris

[Dave45]

Will have a look but they're matched to the flywheel ideally. Are you sure the hydraulics totally free of air?

[Dave45]

is the plate definitely in the right way around?

[colliwobble]

Yes no air in the hydraulics the pedal has pressure all the way and I am certain it is in the right way around.  The more I think about it I think I am going to try and find a pressure plate or a full assemble.